Replacing The Feed Roller - Konica Minolta bizhub 500 Service Manual

3. PERIODIC CHECK
3.13.3

Replacing the feed roller

A. Periodically replaced part/cycle
• Feed roller: Every 750,000 prints (Actual replacement cycle: Every 200,000 prints)
Note
• When replacing the feed roller, be sure also to replace the separation roller assy at the same time.
B. Procedure
[4]
[3]
[2]
66
[3] [2]
[1]
50gaf2c010na
[1]
50gaf2c169na
Field Service Ver1.0 Feb.2006
1.
Remove the bypass unit.
(See P.60)
2.
Remove the push-up plate assy.
(See P.63)
3.
Press the conveyance guide [1] in the arrow-
marked direction [2] to remove the support axis [3]
from the hole [4], and then remove the convey-
ance guide.
4. Open the lever [1]. Remove the 2 screws [2] and
then remove the paper roller cover [3].