Konica Minolta bizhub 500 Service Manual page 894

Field Service Ver1.0 Feb.2006
[1]
[5]
4521f3c017na
3. MECHANICAL ADJUSTMENT
5.
Load 1500 sheets of A3 paper (80 g/m
main tray.
6.
Remove the paper that was put in step 3 to block
the light and let the light of LED19 pass through.
Note
• When letting the light of LED19 pass through,
the main tray starts to go up. Be sure to con-
duct the following steps 7 and 8 while in the
up drive of the main tray.
7.
While in the up drive of the main tray, rotate VR2
[1] on FSCB clockwise.
LED3 [5] on FSCB turns ON.
2
) on the
35