Removing/Reinstalling The Fusing Heater Lamps /1 (L2) And /2 (L3) - Konica Minolta bizhub 500 Service Manual

3. PERIODIC CHECK
3.15.5

Removing/reinstalling the fusing heater lamps /1 (L2) and /2 (L3)

Note
• Be careful not to touch the lamp sections of L2 and L3 with bare hands. When touched, be sure to
clean them with a roller cleaner.
A. Procedure
84
[1]
[2]
50gaf2c097na
Field Service Ver1.0 Feb.2006
1.
Remove the fusing unit.
(See P.76)
2.
Remove the fusing claw assy from the fusing unit.
(See P.78)
3.
Remove the fusing web from the fusing unit.
(See P.80)
4.
Remove the fusing casing.
(See P.82)
5.
Remove the fastons [1] and [2], 2 each.
Note
• When removing the faston, be sure to remove
it by holding the connector section. Be abso-
lutely sure not to pull out by holding the wiring
harness section.