Adjustment/Setting; Mechanical Adjustment; Mis-Centering Adjustment Of The Trays 3 And 4 - Konica Minolta bizhub 500 Service Manual

Field Service Ver. 1.0 Feb. 2006

ADJUSTMENT/SETTING

4.

MECHANICAL ADJUSTMENT

4.1

Mis-centering adjustment of the Trays 3 and 4

Conduct this adjustment when a mis-centering occurs that cannot be adjusted in the service
mode.
A. Procedure
[3] [4]
[2]
[3]
[1]
[2]
[1]
4061f3c001na
4061f3c002na
4. MECHANICAL ADJUSTMENT
1. Pull out the Tray [1].
2. If there remains any paper, remove it
thoroughly.
3. Loosen the 2 screws [2].
4. Move the Paper Guide [3] and adjust the
center position with the marking-off [4]
as a guide.
5. Tighten the 2 screws [2].
6. Set the Tray with paper put it in.
7. Conduct the copy/print operation and
check to see if the mis-centering
between the center [1] of the paper and
the center [2] of the copied image is
within a standard value (± 3 mm or less
[3]).
8. When the value is not within the stan-
dard value, repeat steps 1 to 7 until the
standard value can be obtained.
15