Konica Minolta bizhub 500 Service Manual page 912

Field Service Ver. 1.0 Feb. 2006
[3]
[6]
[7]
[10]
[3]
[4]
4511f2c031na
[6]
[5]
4511f2c032na
[9]
[8]
4511f2c033na
[10]
4511f2c034na
3. Loosen three screws [3] of the stopper.
4. Loosen three screws [4] of the Clincher.
5. Aligning the protrusions of the jig [6]
with the recesses in the Staple Car-
tridge [5], fit the jig to the Stapler.
NOTE
• Make sure that the protrusions of the
jig properly rest in the recesses.
6. Turn the gear [7] of the Clincher and
then slide the Clincher so that the pro-
trusion of the Clincher [9] fits into the
recess in the jig [8].
7. Tighten six screws [10].
NOTE
• Turn the gear again and check to see
that the protrusion of the Clincher
smoothly fits into the recess in the jig.
8. Turn the gear and remove the jig.
3. OTHER
13