Replacing The Separation Roller - Konica Minolta bizhub 500 Service Manual

2. PERIODIC CHECK
[7]
[13] [9]
[12]
[7]
[8]
[14]
[17]
[15]
[16]
[18]
2.1.2

Replacing the Separation Roller

A. Periodically replaced part/cycle
• Separation Roller: Every 500,000 prints (Actual replacement cycle: Every 200,000 faces)
B. Procedure
[1]
[2]
6
[12]
[13]
[11]
[6]
[10]
16eaf2c004na
16eaf2c005na
16eaf2c006na
[2]
[3]
16eaf2c007na
Field Service Ver. 1.0 Feb. 2006
4. Remove two levers [6].
5. Remove five C-rings [7].
6. Remove the arm /Fr [8].
7. Remove the belt [9].
8. Remove the Pick-up Roller Shaft [11]
from the Arm /Rr [10].
9. Remove the 2 Spacers [12] from the
Pick-up Roller Shaft.
10. Remove two Pick-up Rollers [13].
NOTE
• Be sure to take note of the direction of
the pick-up roller when installing it.
11. Remove the C-ring [14], and remove the
gear [15] and the bushing [17].
12. Remove two pins [16].
13. Remove the Feed Roller [18].
NOTE
• Use care not to lose the pin.
1. Open the Open/Close Cover [1].
2. Hold the [2] sections in the figure, and
remove the cover [3].