Konica Minolta bizhub 500 Service Manual page 814

Field Service Ver1.0 Feb.2006
[3]
[4]
[3]
[2]
[1]
16aaf2c012na
[2] [1]
16aaf2c013na
8.
Pull out the shaft [2] while pressing the lever [1]
and remove the separation roller [3].
9.
Remove the separation rubber [2] from the sepa-
ration roller [1].
Note
• Be sure to install the separation rubber [2] so
that the paint mark [3] comes in the opposite
direction of the projection [4].
• When setting the separation rubber, apply
alcohol on the inside of the separation rubber.
By doing so, the separation rubber can be set
more easily.
10.
Reinstall the above parts following the removal
steps in reverse.
2. PERIODIC CHECK
9