Konica Minolta bizhub 500 Service Manual page 911

3. OTHER
[23]
[24]
[25]
Precaution for Clincher Reinstallation
• When the Clincher is installed, the position of the Stapler and the Clincher will be
misaligned. Be sure to perform the following adjustment.
[2]
12
[22]
4511f2c027na
4511f2c028na
[26]
4511f2c029na
[1]
4511f2c030na
Field Service Ver. 1.0 Feb. 2006
22. Remove the harness clamp and unplug
the connector.
23. Remove three screws [22], and remove
the Clincher /1 [23].
24. Remove the Staple Cartridge /1 [24].
25. Remove four screws [25], unplug the
connector, and remove the Stapler /1
[26].
NOTE
• To replace Clincher /2 and Stapler /2,
repeat steps 22 to 25.
1. Use three screws [1] to temporary fix
the Clincher [2].
2. Install the Staple Cartridge.