System Board Jumper Settings; Table 6-1 Default Jumper Settings - Sun Microsystems Netra 240 Service Manual

6
C H A P T E R

System Board Jumper Settings

This chapter contains information on default jumper settings. This information
enables you to restore the default system jumper configurations if required. See
FIGURE 6-1
TABLE 6-1
Caution – Changing the setting for JP1 could cause damage to the server.
Caution – Do not change the settings for the JP5 jumper. Only service personnel
should modify the settings for this jumper.
Note – Illustrations might contain optional components that are not available on all
standard configurations of the Netra 240 server.
TABLE 6-1
Jumper ID
i
JP1
JP2
JP3
for the jumper locations. The default jumper settings are listed in
.
Default Jumper Settings
Default Setting
1-2 Fitted
3-4 Fitted
5-6 Not fitted
7-8 Not fitted
9-10 Fitted
1-2 Not fitted
1-2 Not fitted
Additional Information
Processor core voltage. Do not alter this jumper
setting.
ALOM Flash ROM swap halves. Only service
personnel should modify this setting. Fitting a
jumper affects the swap.
ALOM reset. Used only for testing the system.
103