IDE Controller Failure
The probe-IDE diagnostic transmits an inquiry command to internal and external
IDE devices connected to the system's on-board IDE interface. If the IDE device is
connected and active, the target address, unit number, device type, and
manufacturer name are displayed. Initialize the probe-IDE diagnostic by typing the
probe-ide command at the ok prompt. The following code example shows the
probe-IDE diagnostic:
ok probe-ide
Device 0 ( Primary Master )
ATA Model: ST34342A
Device 1 ( Primary Slave )
ATA Model: ST34342A
ok
Jumper Settings
The default settings for the jumpers are shown below. Do not change these settings.
Jumper Name
JP1
JP3
JP7
JP8
JP9
JP13
JP14
JP15
JP16
JP18
JP19
Jumper Setting
1-2
Not used.
1-2, 5-6.
Not used.
1-2
Jumper not fitted.
Jumper not fitted.
1-2
Jumper not fitted.
Jumper not fitted.
Jumper not fitted.
Chapter 10
Troubleshooting
107