Nortel TAPI User Manual page 92

92 Chapter 4 Configuration guidelines
You can perform the following configurations in the Provider Table window:
• Application name. A string of up to 19 ASCII characters that identifies the
provider application. If you enter more than 19 characters Meridian Link
Services does not operate.
• Timeout values. You can configure timeout values for the following events.
The default values are sufficient for 50 users but you must increase these
values if you are adding more than 50 users
— Initialization — the length of time that Symposium TAPI SP waits to
— Shutdown — the length of time that Symposium TAPI SP waits for
— Command — the length of time that Symposium TAPI SP waits for a
• Call data size. Enter the number of bytes that can be stored as call data. The
default size is 512 bytes but Nortel Networks recommends that you change
this size to reflect actual requirements to minimize the amount of network
load allocated to call data traffic. The maximum call data size is 4096 bytes.
• Call data life span. Enter the length of time that call data will be stored.
• Disable copy of call data to consultative call. A new feature introduced in
Symposium TAPI Service Provider for Succession, release 2.3.1 allows you
to disable copying call data when calls are transferred or conferenced.
• Log style. Select the number of log style to use for troubleshooting purposes.
The default style is 1 and you can create new log styles in the Log Styles
window.
213346.02
establish communication with the switch before generating an error. The
default and minimum value is 32 seconds.
shutdown to be completed before generating an error. The default value
and minimum value is 32 seconds.
command response before generating an error. The default and minimum
value is five seconds.