Connecting The Server To The Elan Subnet - Nortel CallPilot Installation Manual

7
8
What is next?
Connect the server to the ELAN and CLAN hubs (if applicable).
IF the server will
be connected to the ELAN Subnet
be connected only to a Nortel server
subnet
not be connected to either the ELAN
subnet or Nortel server subnet

Connecting the server to the ELAN subnet

Connect the CallPilot server to the Meridian 1 switch or CS 1000 system
using the Embedded LAN (ELAN).
For important considerations about using the ELAN subnet in your network, see
the Planning and Engineering Guide (NN44200-200).
To comply with EMC requirements, a Class A hub must be located 10 m (33
feet) away from the 703t server.
To connect the server to the ELAN subnet (Meridian 1 or CS 1000 only)
Step
1
Copyright © 2007, Nortel Networks
.
the power outlets of the CallPilot server and the power outlets of
the switch.
Connect the power cord to the modem, and plug the other end into
a wall receptacle or power bar.
Turn on the modem.
Action
Locate the ELAN Ethernet connector on the back of the server.
Note: The ELAN connector is labeled as NIC1 10/100 MB. For
the connector location, see the diagram on
Nortel CallPilot
703t Server Hardware Installation
NN44200-304 01.01 Standard
5.0 23 February 2007
Connecting the server to the ELAN subnet 41
—End—
THEN
continue with
to the ELAN subnet" (page
continue with
to the Nortel server subnet (optional)"
(page 42).
continue with installing the software
feature dongle. See
Nortel software feature dongle" (page
43).
ATTENTION
ATTENTION
"Connecting the server
41).
"Connecting the server
"Installing the
page 52.
Nortel Networks Confidential