Christie CineLife+ CP4415-RGB Service Manual page 84

7. Slide the power supply assembly over the rails and out of the projector, and set it on a clean,
level surface.
8. Remove the two screws securing the handle bracket to the power supply assembly.
9. Remove the eight screws securing the support bracket around the power supply assembly.
10. Remove the affected power supply module.
11. Replace it with the new power supply module.
12. To re-install, follow these steps in reverse order.
When reconnecting the DC outputs, ensure all positive and negative terminal connections are
torqued to 30 in-lb.
When correctly oriented in the projector, the 12V power supply is located at the top of the
assembly, with the handle and support brackets fitting over the three locating pins.
CineLife+ 4K-RGB Service Guide–CP4415-RGB, CP4420-RGB, CP4425-RGB, CP4435-RGB
020-103257-02 Rev. 1 (08-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Electronics
84