Dual Temperature Sensor Module (Dtsm); Light Engine Temperature Sensor - Christie CineLife+ CP4415-RGB Service Manual

Dual temperature sensor module (DTSM)

The dual temperature sensor module (DTSM) monitors the ambient air temperature going into the
projector.
1. Remove the side-intake cover (on page 47).
2. Disconnect the DTSM inline harness connector F and connector J82.
3. Remove the screw securing the DTSM.
4. Replace the DTSM.
5. To re-install, follow these steps in reverse order.

Light engine temperature sensor

The temperature sensor is located on the light engine.
1. Remove the light engine.
2. Disconnect the connector to the temperature sensor.
3. Remove the screw securing the temperature sensor and remove it.
CineLife+ 4K-RGB Service Guide–CP4415-RGB, CP4420-RGB, CP4425-RGB, CP4435-RGB
020-103257-02 Rev. 1 (08-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Printed circuit boards and sensors
116