Zoom And Focus Assembly - Christie CineLife+ CP4415-RGB Service Manual

7. Pull out the integrator assembly through the back of the projector and place it on a clean, flat
surface.
To keep out dust and other contaminant, Christie recommends covering the LOS opening with
a lint-free cloth.
8. To re-install, follow these steps in reverse order.
9. After replacing the integrator assembly, perform the tasks described in Adjusting the LOS
coupling mirrors (on page 19) and LiteLOC sensor-to-screen calibration (on page 27).

Zoom and focus assembly

The zoom and focus assembly is located at the front of the integrator assembly.
1. Remove the integrator assembly (on page 92).
2. Remove the three screwdriver tools.
3. Remove the three screws securing the tool holder bracket.
4. Remove the tool holder bracket.
5. Remove the screws securing the plastic cover.
CineLife+ 4K-RGB Service Guide–CP4415-RGB, CP4420-RGB, CP4425-RGB, CP4435-RGB
020-103257-02 Rev. 1 (08-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Optics
96