2. Remove the front cover (on page 47).
3. Make sure the lens mount is centered vertically and horizontally.
4. Disconnect the lens mount harness.
5. Remove the harness cables from the four P-clips.
6. Loosen the two boresight alignment screws.
Ensure the lens mount is supported while removing the screws as no pins are available to rest
it on and it will fall off.
7. Loosen the pivot screw in the center of the lens mount.
CineLife+ 4K-RGB Service Guide–CP4415-RGB, CP4420-RGB, CP4425-RGB, CP4435-RGB
020-103257-02 Rev. 1 (08-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Lens mount components
52