Laser Boards For Cp4425-Rgb And Cp4435-Rgb - Christie CineLife+ CP4415-RGB Service Manual

Laser boards for CP4425-RGB and CP4435-RGB

The laser driver card cage includes three CS12G0 boards for CP4425-RGB and four CS12G0 boards for
CP4435-RGB.
Always use an anti-static wrist strap and use a grounded anti-static mat when handling circuit boards.
1. Remove the rear cover (on page 45).
2. Remove the radiator (on page 69).
3. Remove the radiator intake fans (on page 59).
4. For CP4425-RGB, disconnect the 14 harnesses from the side of the laser driver cage.
5. For CP4435-RGB, disconnect the 18 harnesses from the side of the laser driver cage.
6. Disconnect the laser driver exhaust fan harness connector.
7. Loosen the four screws and remove the laser driver cage.
8. Remove the four cage screws.
CineLife+ 4K-RGB Service Guide–CP4415-RGB, CP4420-RGB, CP4425-RGB, CP4435-RGB
020-103257-02 Rev. 1 (08-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Printed circuit boards and sensors
111