nanoString GeoMx DSP User Manual page 95

MAN-10152-01 for software v2.5
Administration Menu
S U
OFTWARE PDATE
Refer to the software version-specific installation instructions. These are released with each
new GeoMx DSP Instrument software version.
IMPORTANT: If your GeoMx is configured to use an auxiliary server, it is required to update
the NanoString software on the auxiliary server as soon as the GeoMx DSP software update is
complete. See MAN-10135 GeoMx Auxiliary Server Software Installation Manual at
http://www.nanostring.com/geomx-software-updates. Until the auxiliary server software is
updated, studies will not be able to be opened or created.
B G M DSP S
RING EO X
There are two points in the workflow where the software
is considered to be in an idle state: Replace Plate and
Collection Complete. If not already in an idle software
state, do the following:
1. Click Data Collection, then New/Continue Run.
2. Click Assist (wrench icon), then Restart Data Collection Workflow.
3. If there is a plate in the instrument, you'll see Replace Plate?
here – this is an idle software state.
4. If there is not a plate in the instrument, you'll be prompted to load one when the run is
restarted. The slide holder should be empty of slides and loaded in the instrument.
5. Wait for pop-up message "No Slides Detected". Click OK. Now, the instrument is at the
Collection Complete idle software state
6. Click Administration, then Software Update to
perform software update.
7. Refer to the software version- specific installation
instructions. These are released with each new GeoMx
DSP Instrument software version.
FOR RESEARCH USE ONLY. Not for use in diagnostic procedures.
I S
OFTWARE TO AN DLE
(see Figure
GeoMx DSP Instrument User Manual
S
OFTWARE TATE
Figure 89: Replace Plate idle state
(see Figure 89)
90).
Figure 90: Collection Complete idle
Pause
state
95