nanoString GeoMx DSP User Manual page 26

GeoMx DSP Instrument User Manual
Start a New Run
Insert the Collection Plate
1. Open the plate holder clamp.
2. Insert the collection plate onto the plate holder
Figure 13).
3. Fasten the clamp (see Figure
4. Once the clamp is fastened, the system will display the
next step.
Cover/Uncover the collection plate
This prompt will appear if your collection plate was loaded
before your slides. Covering the collection plate
Figure 15) as you load the slide holder onto the stage
prevents contamination from spills or debris.
Once the plate cover is moved (according to the prompt),
the system will display the next step.
The plate must be uncovered for the instrument run.
FOR RESEARCH USE ONLY. Not for use in diagnostic procedures.
26
(see
14).
(see
MAN-10152-01 for software v2.5
Figure 13: Insert the collection plate
onto the plate holder when prompted
Figure 14: Fasten the clamp on the
collection plate
Figure 15: Cover the collection plate
when prompted