Table of Contents
Advertisement
GeoMx DSP Instrument User Manual
Instrument Introduction
The backside of the GeoMx DSP instrument
An ethernet connection: CAT 6 Network Port with RJ45 connector.
l
Three USB connections: USB-A 3.0.
l
A power input for the instrument: Power in 100 – 240 VAC, 50/60 Hz, connector C14.
l
A power output for the monitor: Power out (same as Power in), connector C13.
l
A display port for the monitor.
l
FOR RESEARCH USE ONLY. Not for use in diagnostic procedures.
12
Figure 5: GeoMx DSP instrument backside diagram
(see Figure 5)
MAN-10152-01 for software v2.5
has the following ports:
Advertisement
Table of Contents
