Table of Contents
Advertisement
GeoMx DSP Instrument User Manual
GeoMx DSP Control Center
GeoMx DSP Control Center
The GeoMx DSP Control Center is the main interface of the GeoMx DSP software.
By clicking the Data Collection button in the GeoMx DSP Control Center header
7), you can begin a new run or upload counts or calibration files. The Records button allows you
to create slide records and scan parameters and to add scans to the Data Analysis Queue.
Select the Data Analysis button to build a study from the queue or open a study. The
Administration button is available to administrative users.
The Data Collection Stages, depicted just below the header when Data Collection is selected,
provide you with a visual orientation of the progress of your run.
The Notifications bell will alert you to errors in archiving, the status of readout file upload, and
the status of a data analysis build. These notifications will remain until you click the bell; once
seen, they will persist for 24 hours or until closed with the x (archiving errors may regenerate
hourly).
Slide and Plate Status indicators in the footer indicate the current state of the slides and plate,
respectively.
Reagent Status indicators depict the reagent and waste bottle levels. A locally logged-in user
may use the Abort Run button, if necessary, to halt the run.
FOR RESEARCH USE ONLY. Not for use in diagnostic procedures.
20
Figure 7: GeoMx DSP Control Center diagram
MAN-10152-01 for software v2.5
(see Figure
Advertisement
Table of Contents
