Table of Contents
Advertisement
GeoMx DSP Instrument User Manual
GeoMx DSP Instrument Reagents
GeoMx DSP Instrument Reagents
The GeoMx DSP instrument requires the following reagent bottles in the reagent bay
Figure
95):
Buffer S: 1 L bottles in reagent bay slots 1 and 4.
l
Buffer H: 250 mL bottles in reagent bay slots 2 and 3.
l
In addition, the waste bottle, with adequate space to collect waste, must be present in the
position to the right of the reagent bottles.
IMPORTANT:
Ensure the instrument is in an idle software state before changing reagents (see
Bring GeoMx DSP Software to an Idle Software State on page
off any reagents. Always replace entire bottles when reagents are low, using the wizard.
IMPORTANT:
Do not open the reagent bay door during a run, unless prompted by the system to
change reagents. Opening the door may interrupt and abort the current run.
FOR RESEARCH USE ONLY. Not for use in diagnostic procedures.
100
Figure 95: GeoMx DSP instrument reagent bay diagram
MAN-10152-01 for software v2.5
95). In addition, DO NOT top
(see
Advertisement
Table of Contents
