Table of Contents
Advertisement
MAN-10152-01 for software v2.5
Select ROIs & Segment
Open the Scan Workspace
There are two ways to access the Scan Workspace:
1. During the DSP run, use the Edit ROIs button
Figure 22)
, which will become active underneath a
slide's image after the 20x scan has completed.
2. To access the Scan Workspace from outside of the DSP run workflow, select the Records
button from the DSP Control Center. Use the Navigation window to browse to your scan and
select it. On your scan card, select the Scan Workspace link
FOR RESEARCH USE ONLY. Not for use in diagnostic procedures.
(see
Figure 23: Scan card with Scan Workspace link
GeoMx DSP Instrument User Manual
Figure 22: Control Center single
slot view of Edit ROIs button
activated after scanning
(see Figure
23).
37
Advertisement
Table of Contents
