Table of Contents
Advertisement
MAN-10152-01 for software v2.5
Administration Menu
I
B
S
LLUMINA
ASE
PACE
This menu option is only visible when accessing the GeoMx DSP Control Center over a
remote connection using the Chrome browser. Users may connect their GeoMx DSP to their
Illumina BaseSpace workgroup(s) to enable seamless end-to-end workflows. These
workflows allow a sequencing job to be sent from the GeoMx DSP directly to the BaseSpace
Sequence Hub, eliminating the file processing steps of the conventional workflow.
Requirements:
• Use of Illumina NextSeq 1000/2000 sequencing platform
• Active DRAGEN subscription on the NextSeq 1000/2000
To add a connection to a BaseSpace Workgroup:
1. Access the GeoMx DSP over Chrome from a separate computer. Log in as an
administrative user.
2. Click on the Administration menu, then Illumina BaseSpace Admin.
3. Click Add Connection to BaseSpace Workgroup.
4. In the pop- up window
connection.
5. From the drop-down menu, select
the region of your BaseSpace
account (typically the region closest
to your geographic location).
DO NOT click Connect yet.
6. Open a new Chrome browser tab
and navigate to the BaseSpace
Sequence Hub. Log in to your
account and select the Workgroup
to which you wish to connect. The
same workgroup must be used
to log into the NextSeq 1000/2000
instrument and BaseSpace
Sequence Hub. Leave this
browser tab open.
FOR RESEARCH USE ONLY. Not for use in diagnostic procedures.
A
DMIN
(see Figure 74)
, create an Account Name for this workgroup
GeoMx DSP Instrument User Manual
Figure 74: Illumina BaseSpace Admin pop-up
85
Advertisement
Table of Contents
