Table of Contents
Advertisement
MAN-10152-01 for software v2.5
Administration Menu
G
M
D
A
EO
X
ATA
NALYSIS
An auxiliary server provides additional computing power for the GeoMx DSP Data Analysis
software. This server is required for analysis of Cancer Transcriptome Atlas or Whole
Transcriptome Atlas data. Learn more about the options to provide your own server or
purchase a pre- configured server from NanoString by contacting your NanoString
representative. Set up the server by installing its software according to GeoMx DSP Auxiliary
Server Software Manual (MAN-10135), then pairing it with the GeoMx DSP following the steps
below.
Ensure that there are no Data Analysis sessions in progress when configuring the auxiliary server;
any sessions in progress will be terminated.
Note that the GeoMx Data Analysis Auxiliary Server software must be updated each time the paired
GeoMx DSP instrument software is updated.
1. Select GeoMx Auxiliary Server from the Admininstration menu.
2. Click the Configure button
3. Input the IP Address of the server. This should be a Static IPV4 address. Click Next.
4. If the GeoMx system is able to identify the IP Address, you will receive a successful
message. Click Next.
If the GeoMx system is unable to verify the IP address, you will be provided with the
l
option to either cancel the configuration or try again with a new IP address.
5. Enter the six digit pin provided to you during the installation of the GeoMx Auxiliary
Server software. Contact
Click Next.
FOR RESEARCH USE ONLY. Not for use in diagnostic procedures.
A
S
UXILIARY
ERVER
Figure 69: Auxiliary server configuration window before pairing
(see Figure
69).
GeoMxSupport@nanostring.com
GeoMx DSP Instrument User Manual
if you do not know this number.
81
Advertisement
Table of Contents
