nanoString GeoMx DSP User Manual page 89

MAN-10152-01 for software v2.5
Administration Menu
N S
ETWORK ETTINGS
The Network tab allows you to adjust network settings
Static IP Address from the drop-down menu.
In the Network window, Machine Name and IP address are displayed. If they are not displayed,
restart the system by shutting down from the System Settings tab, switching off the power switch on
the back, waiting one minute, then switching power switch on.
Instructions to remotely connect to your DSP instrument
When connected to your system remotely, you can analyze data, select or modify ROIs, and
export images.
1. Connect the GeoMx DSP instrument to your network with a network cable.
2. Log into the GeoMx DSP system with an administrative username and password.
3. Select the Administration button in the DSP Control Center.
4. From the Administration menu, select Network.
5. Note the Machine Name and the IP address listed in the Network Settings window.
6. From your remote computer, open a Chrome browser.
7. Browse to https://geomx-#### where #### is the GeoMx Machine Name you noted from
the Network Settings window. In the example
https://geomx-B0008.
8. If this does not work, your network may
not pass on the GeoMx instrument
name. In this case, enter the direct IP
address. In the example
79), the address would be
https://10.5.0.244.
9. This should return the GeoMx DSP login
screen, where you can log in with your
user account. You will be able to perform
data analysis, select ROIs, and export
images.
Closing the Chrome browser will automatically log you out of the GeoMx system.
FOR RESEARCH USE ONLY. Not for use in diagnostic procedures.
(see Figure
GeoMx DSP Instrument User Manual
(see Figure 79). Select Dynamic or
(see Figure 79) , the address would be
Figure 79: Network tab under Administration
89