Key Switch Lock Cable Assembly - Sun Microsystems Enterprise 3500 System Reference Manual

E.4.5

Key Switch Lock Cable Assembly

E.4.5.1 Removing the Key Switch Lock Cable Assembly
1. Remove the panels covering the key switch lock cable assembly.
Complete the steps in Section E.4 "Removing the Front and Side Panels."
2. Disconnect the key switch lock cable from the LED board.
a. Pull forward on the two locking tabs securing the cable to the LED board.
The key switch lock cable is in front of the key switch PWB centerplane cable.
(
FIGURE E-9
b. Disconnect the cable.
3. Remove the two screws that attach the key switch lock assembly to the chassis.
4. Twist the key switch lock assembly to the left and pull it forward and out away
from the chassis.
The key switch lock assembly has a hook that sits on the bracket in the chassis. You
need to turn the assembly so that the hook clears the bracket before the key switch
lock assembly can be removed (
E-14 Sun Enterprise 3500 System Reference Manual • August 2001
).
FIGURE E-10
).