Using A Remote Console; Table 9-4 Remote Console Commands - Sun Microsystems Enterprise 3500 System Reference Manual

9.6.2

Using a Remote Console

It is possible to reset the system or cycle power from the remote console under these
conditions:
The console must be connected to port A on the clock+ board.
The key switch must be in either the On or Diagnostic setting. If the key switch is
in the Secure or Off position, the remote key sequences and button resets are
ignored.
Security features permit the use of the remote console.
You must use a slow typing speed, not less than 0.5 seconds and not more than 5
seconds between characters.
TABLE 9-4
Command
Remote power off/on
Remote system reset
Remote XIR (CPU) reset
Key:
Return = ASCII 0d hexadecimal,
~ (tilde) = ASCII 7e hexadecimal,
Control-Shift-p = 10 hexadecimal,
Control-Shift-r = 12 hexadecimal,
Control-Shift-x = 18 hexadecimal.
Note – The remote console logic circuit continues to receive power, even if you have
commanded system power off.
The remote system reset command is useful for resetting the system under general
conditions. The remote XIR reset command is used for software development and
debugging.
9-14 Sun Enterprise 3500 System Reference Manual • August 2001
Remote Console Commands
Enter this sequence
Return Return ~ Control-Shift-p
Return Return ~ Control-Shift-r
Return Return ~ Control-Shift-x