Removing The Front And Side Panels; Removing The Side Panels And Front Bezel - Sun Microsystems Enterprise 3500 System Reference Manual

2. Slide the auxiliary fan tray assembly toward the centerplane.
The auxiliary fan tray assembly will not seat fully unless the lever is in this starting
position.
Caution – DO NOT FORCE the auxiliary fan tray assembly into the slot; this can
cause damage to the auxiliary fan tray and system.
The auxiliary fan tray assembly should insert and seat smoothly. If it binds, remove
it, and inspect the slot for any obvious obstructions. Do not damage the
springfingers at the bottom of the auxiliary fan tray assembly.
3. Swing the extraction lever inward to the locked position to seat the auxiliary fan
tray assembly.
Do not press on the front panel of the auxiliary fan tray assembly to seat it; doing so
will damage the connector pins.
4. Lock the auxiliary fan tray to the system chassis by inserting a Phillips #1
screwdriver into each quarter-turn access slot and then turning to the locked
position (
E.4

Removing the Front and Side Panels

Complete the following section as a prerequisite if you are removing one of the
following subassemblies:
Media (SCSI) tray data and DC power cable assemblies
Key switch PWB centerplane cable assembly
Key switch lock cable assembly
LED board
Centerplane
E.4.1

Removing the Side Panels and Front Bezel

1. Completely power off the Enterprise 3500 system.
See the power-off instructions in Chapter 11 "Powering Off and On."
2. Remove the side panels.
Grasp the bottom of the side panel in the center and pull the panel out slightly
until the snap disengages.
Lift the side panel up and then lift the panel out (
E-6 Sun Enterprise 3500 System Reference Manual • August 2001
).
FIGURE E-2
).
FIGURE E-4