Parameters; Parameters For The Im151-1 Basic Interface Module; Parameter Description; Enable Startup For Set <> Actual Configuration - Siemens SIMATIC ET 200S Manual

Parameters

2.1

Parameters for the IM151-1 BASIC interface module

Table 2- 1
Operation at set < > actual
configuration
Identifier-related diagnostics
Module status
Channel-specific diagnostics

Analog-value format

Interference frequency
suppression
Reference junction slot
Reference junction input
1
2.2

Parameter description

2.2.1 Enable startup for set <> actual configuration
When this parameter is enabled, and
● Modules removed and inserted during operation will not lead to a ET 200S station failure.
● The actual configuration differs from the expected configuration, the ET 200S remains
When this parameter is disabled, and
● Modules removed and inserted during operation will lead to an ET 200S station failure.
● The actual configuration differs from the expected configuration, there is no data transfer
2.2.2 Analog-value format
Here you set the number format for all analog electronic modules.
IM151-1 BASIC interface module (6ES7151-1CA00-0AB0)
Manual, 07/2008, A5E01075925-02
Parameters for the IM151-1 BASIC interface module
IM151-1 BASIC
1
The parameter only exists when configuring using the GSD file.
engaged in data transfer with the DP master.
between the DP master and the ET 200S.
Value range
disable/enable
disable/enable
disable/enable
disable/enable
SIMATIC S7/
SIMATIC S5
50 Hz / 60 Hz
None / 2 to 12
RTD on
channel 0/RTD on
channel 1
Default setting
disable ET 200S
enable ET 200S
enable ET 200S
enable ET 200S
S7 ET 200S
50 Hz ET 200S
None ET 200S
0 ET 200S
2
Applicability
11