Configuring The Device; Accessing The Compactflash Card - Siemens SIMATIC NET RUGGEDCOM RX1510 Equipment Manual

Communication Ports
Connect any of the available Ethernet ports on the device to a management
switch and access the RUGGEDCOM RX1510 console and Web interfaces via the
device's IP address. The factory default IP address for the RUGGEDCOM RX1510 is
https://192.168.0.2.
For more information about available ports, refer to "Modules" (Page 27).
Note
Single-mode fiber ports only support Ultra Physical Contact (UPC) cable connectors.
3.2

Configuring the Device

Once the device is installed and connected to the network, it must be configured.
All configuration management is done via the RUGGEDCOM RX1510 interface. For
more information about configuring the device, refer to the "RUGGEDCOM ROX II
Configuration Manual" associated with the installed software release.
3.3

Accessing the CompactFlash Card

The RUGGEDCOM RX1510 features a removable CompactFlash (CF) card that stores
configuration files, firmware (active and backup versions), file-based feature keys
and other system files.
Configuration hazard – risk of data corruption/loss
Do not remove or insert the CF card when the device is powered on.
The CF card should only be removed in the following scenarios:
•
•
•
RUGGEDCOM RX1510
Equipment Manual, 10/2023, C79000-G8976-1055-25
Pin
2
3
4
5
6
7
8
NOTICE
The chassis is defective (with the exception of power and media modules)
The CF card is deemed defective or corrupt
The device is rendered non-functional due to a serious configuration error, data
corruption, or hardware fault
Name
RX-
TX+
Reserved (Do Not Connect)
Reserved (Do Not Connect)
TX-
Reserved (Do Not Connect)
Reserved (Do Not Connect)
Device Management
3.2 Configuring the Device
Description
Receive Data-
Transmit Data+
Transmit Data-
23