To Run The Cycle Pick/Place Test - Sun Microsystems SPARCstorage Library Service Manual

2
2-36
1. Disable security (the display panel reads Set Security On when security is
disabled).
If the display panel reads Set Security Off, security is turned on. See "To
enable or disable security" on page 2-22.
2. Put the tape library into LCD Interface mode:
a. Press Escape until the primary menu is displayed.
b. Select the Interface Menu by pressing
c. Select the Control Mode Menu by pressing
d. Select LCD Interface mode by pressing
3. Select the Maintenance Menu by pressing
4. Select the Diagnostics Menu by pressing
5. Select Home CHM by pressing
To abort this diagnostic, press Escape and then Enter.

To run the Cycle Pick/Place test

The Cycle Pick/Place test picks a cartridge from the element you specify and
places it back in the same element. You can specify the number of times you
want this test repeated.
1. Disable security (the display panel reads Set Security On when security is
disabled).
If the display panel reads Set Security Off, security is turned on. See "To
enable or disable security" on page 2-22.
2. Put the tape library into LCD Interface mode:
a. Press Escape until the primary menu is displayed.
b. Select the Interface Menu by pressing
c. Select the Control Mode Menu by pressing
d. Select LCD Interface mode by pressing
3. Select the Maintenance Menu by pressing
4. Select the Diagnostics Menu by pressing
SPARCstorage Library Service Manual—June 1995
↓ ↑
or , then Enter.
↓ ↑
or , then Enter.
↓ ↑
or , then Enter.
↓ ↑
or , then Enter.
↓ ↑
or , then Enter.
↓ ↑
or , then Enter.
↓ ↑
or , then Enter.
↓ ↑
or , then Enter.
↓ ↑
or , then Enter.
↓ ↑
or , then Enter.
↓ ↑
or , then Enter.