To Run The Scan Test - Sun Microsystems SPARCstorage Library Service Manual

6. Select the element index of the cartridge slot (shown in the upper right
corner) from which you want the CHM to pick the cartridge by
↑ ↓
pressing or , then Enter.
See Figure 2-4 on page 2-27. The system displays the following screen:
Set Destination
↑ Increase
↓ Decrease
7. Select the element index of the cartridge slot (shown in the upper right
corner of the display panel) from which you want the CHM to place the
cartridge by pressing
The CHM moves the cartridge from the source to the destination.

To run the Scan test

The Scan test scans all tape bar code labels. The information is stored in CHM
memory and the results of the scan are displayed on the Label Information
screen. To view the results, see "To display bar code label information" on
page 2-55 in the Inventory Menu (a submenu of the Library Info Menu).
1. Disable security (the display panel reads Set Security On when security is
disabled).
If the display panel reads Set Security Off, security is turned on. See "To
enable or disable security" on page 2-22.
2. Put the tape library into LCD Interface mode:
a. Press Escape until the primary menu is displayed.
b. Select the Interface Menu by pressing
c. Select the Control Mode Menu by pressing
d. Select LCD Interface mode by pressing
3. Select the Maintenance Menu by pressing
4. Select the Diagnostics Menu by pressing
5. Select Scan by pressing
The element where the bar code scanner is currently located is scanned.
To abort this diagnostic, press Escape and then Enter.
Troubleshooting
↑ ↓
or , then Enter.
↓
or
↓
↓
or
↓
or
↓ ↑
or , then Enter.
2
↑
, then Enter.
↓ ↑
or , then Enter.
↑
or , then Enter.
↑
, then Enter.
↑
, then Enter.
2-33