To Run The Cycle Solenoid Test - Sun Microsystems SPARCstorage Library Service Manual

2
2-40
6. Select the number of cycles (in increments of ten) you want the Cycle L
Axis test to run. Press
To abort this diagnostic, press Escape and then Enter.

To run the Cycle Solenoid test

The Cycle Solenoid test exercises the solenoid that controls the locking
mechanism on the front door.
1. Disable security (the display panel reads Set Security On when security is
disabled).
If the display panel reads Set Security Off, security is turned on. See "To
enable or disable security" on page 2-22.
2. Put the tape library into LCD Interface mode:
a. Press Escape until the primary menu is displayed.
b. Select the Interface Menu by pressing
c. Select the Control Mode Menu by pressing
d. Select LCD Interface mode by pressing
3. Select the Maintenance Menu by pressing
4. Select the Diagnostics Menu by pressing
5. Select Cycle Solenoid by pressing
The system displays the following screen:
Set Cycles
↑ Increase
↓ Decrease
6. Select the number of cycles, in increments of ten, (up to 250) you want the
Cycle Solenoid test to run by pressing
You will hear a clicking sound.
To abort this diagnostic, press Escape and then Enter.
SPARCstorage Library Service Manual—June 1995
↑ ↓
or , then Enter.
↓ ↑
or
↓
or
↓
or
↓
or
↓ ↑
or , then Enter.
10
↑ ↓
or , then Enter.
, then Enter.
↓ ↑
or , then Enter.
↑
, then Enter.
↑
, then Enter.
↑
, then Enter.