Removing The Power Supply - Sun Microsystems SPARCstorage Library Service Manual

6
6.2 Power Supply
6.2.1 Preparing to Remove and Replace the Power Supply

6.2.2 Removing the Power Supply

6-6
3. Tighten the two captive screws on each end of the drive carrier faceplate.
See Figure 6-3.
4. Remove the wrist strap.
1. Turn off the power and disconnect the power cord.
2. Obtain the following tools:
• long flatblade screwdriver
• T-20 TORX screwdriver
• Phillips screwdriver
1. Position the unit with the back facing you.
SPARCstorage Library Service Manual—June 1995