Set Serial Number; To Enter The Serial Number Into The Firmware - Sun Microsystems SPARCstorage Library Service Manual

2.3.2.9 Set Serial Number

A label on the back of the unit displays the serial number. To enter the serial
number in the tape library firmware, use the Set Serial Number option.

To enter the serial number into the firmware

1. Disable security (the display panel must read Set Security On when
security is disabled or turned off).
If the display panel reads Set Security Off, security is turned on. See "To
enable or disable security" on page 2-22.
2. Select the Configuration Menu by pressing
3. Select Set Serial Number by pressing
4. Change the serial number.
a. Move from column to column by pressing
b. Change each digit by pressing
c. Press Enter.
The following screen displays:
The serial number is
NNNNNN. Press
ENTER to accept or
ESC to cancel.
5. Press Enter to save the changes or Escape to cancel the changes.
Troubleshooting
↓ ↑
or , then Enter.
↓ ↑
or , then Enter.
← →
or .
↑ ↓
or .
2
2-23