Sun Microsystems SPARCstorage Library Service Manual page 190

D
D-6
Table D-3 Illegal Request Sense Key (5h) ASC and ASCQ Values (Continued)
ASC ASCQ
Byte 12 Byte 13
3Bh 85h
3Bh 86h
3Bh 87h
3Bh 90h
3Dh 00h
3Fh 87h
3Fh 88h
53h 02h
80h 01h
80h 03h
80h 04h
80h 05h
80h 06h
85h 01h
SPARCstorage Library Service Manual—June 1995
Description
The destination for the MOVE MEDIUM command
cannot be the CHM.
The source for the MOVE MEDIUM command cannot
be the CHM.
A cartridge is stuck in the tape drive.
The source cartridge is loaded inside the tape drive
and is not accessible.
There were invalid bits in the identify message. Either
one of the reserved bits was nonzero or the LUNTAR
field was nonzero.
The tape library cannot execute a read or write
firmware command. The write firmware operation is
in progress.
The tape library cannot execute a read or write
firmware command. The read firmware operation is
in progress.
A media load or unload operation was prevented with
a PREVENT/ALLOW MEDIUM REMOVAL
command.
There was a cartridge in the grab base during power
up, before a cartridge move, or before a diagnostic
test.
The source cartridge magazine is not installed.
The destination cartridge magazine is not installed.
The source tape drive is not installed.
The destination tape drive is not installed.
The bar code scanner is not installed.