Diagnostics; Sundiag System Exerciser; To Set The Sparcstorage Library To One Of The Sequential Modes To Run Sundiag - Sun Microsystems SPARCstorage Library Service Manual

3.1 SunDiag System Exerciser

To set the SPARCstorage Library to one of the Sequential Modes
to run SunDiag

Diagnostics

This chapter is organized in the following major sections:
SunDiag System Exerciser
Diagnostics Menu
The SPARCstorage Library must be in one of the three sequential modes
(Sequential CTS1, Sequential CTS2, or Dual Sequential) to use the SunDiag
system exerciser. Any of the sequential modes causes the unit to automatically
get the next tape and load it into the drive.
1. Make sure the tape library is in the ready state.
There should be no hardware errors and the door should be closed.
2. Disable security (the display panel reads Set Security On when security is
disabled or turned off).
If the display panel reads Set Security Off, security is turned on. See "To
enable or disable security" on page 2-22.
3
page 3-1
page 3-2
3-1