To Run The Slot Demo Test - Sun Microsystems SPARCstorage Library Service Manual

2
2-26
To stop the demo, press Escape then Enter.
Note – If you cannot press the Escape or Reset keys, power cycle the tape
library.

To run the Slot Demo test

1. Disable security (the display panel reads Set Security On when security is
disabled).
If the display panel reads Set Security Off, security is turned on. See "To
enable or disable security" on page 2-22.
2. Put the tape library into LCD Interface mode:
a. Press Escape until the primary menu is displayed.
b. Select the Interface Menu by pressing
c. Select the Control Mode Menu by pressing
d. Select LCD Interface mode by pressing
3. Select the Maintenance Menu by pressing
4. Make sure that there is at least one tape present and one empty slot before
beginning the Slot Demo test.
5. Select Demo Menu by pressing
6. Select Slot Demo by pressing
The system begins the demo and displays this screen:
SLOT DEMO:
Total Cycles: N
Status: Move NN - NN
Moving to Slot N
Where:
N
NN- NN
To stop the demo, press Escape and then Enter.
SPARCstorage Library Service Manual—June 1995
↓ ↑
or
↓
or
↓
or
↓ ↑
or , then Enter.
↓ ↑
or , then Enter.
Indicates the number of cycles that have run so far.
Indicates the source and destination element indexes of
the current move.
, then Enter.
↓ ↑
or , then Enter.
↑
, then Enter.
↑
, then Enter.