Set Security; To Enable Or Disable Security - Sun Microsystems SPARCstorage Library Service Manual

2

2.3.2.8 Set Security

2-22
The security option allows you to prevent a user from inadvertently changing
important settings and operations.
Note – Security remains in effect after resetting the tape library.
When security is enabled, a user cannot access the following activities:
•
Changing the control mode
•
Changing the SCSI IDs
•
Changing the library serial number
•
Changing SCSI parity checking
•
Using the Diagnostics Menu and the Demo Menu
•
Using the Clean Drives Menu
•
Opening the front door (LCD security only)
If a user attempts to perform any of the these operations when security is
enabled, (the display panel reads Set Security Off) the tape library displays a
message stating security is active.

To enable or disable security

1. Select the Configuration Menu by pressing
2. Select Set Security On/Off by pressing
When security if turned on, the display panel reads Set Security Off. When
security if turned off, the display panel reads Set Security On.
3. Select a three digit password (something easy to remember.)
To disable security, enter the same password used to turn security on.
a. Move from column to column by pressing
b. Change the password (default password is 000) by pressing
c. Make the password active by pressing Enter.
Note – If you forgot the password, try entering the default password, 000.
SPARCstorage Library Service Manual—June 1995
↓ ↑
or , then Enter.
↓ ↑
or , then Enter.
← →
or .
↑ ↓
or .