Running An Internal Test - Sun Microsystems StorEdge L280 Manual

4.8

Running an Internal Test

1. To run an internal test, press the Next key to enter the following:
ADMIN * / PSWD ### ### ### / TEST *
2. When
3. Press the
4.
NUM LOOPS 1
the desired test loop is displayed, then press
Note – Press
before cancelling.
completes.
Descriptions of the internal tests available from the control panel are in
TABLE 4-4
Test Name
EMPTY DRIVE
REWIND MEDIA
LOAD/UNLOAD
DRIVE IO
SLOT IO
4-10 StorEdge L280 Service Manual • February 1998
is displayed, press
TEST *
button until the desired test is displayed, and press
Next
is displayed, where the 1 is flashing. Press
Cancel at any time to abort a test. The last test cycle will complete
TEST CANCEL
Tests Available From the Control Panel
Description
Do not run this test if the Autoloader contains a tape cartridge with
data. Moves a cartridge out of the drive mechanism and returns it
to its home storage slot if the locations are known, otherwise a
cartridge is placed into the first available storage slot.
Do not run this test if the Autoloader contains a tape cartridge with
data. Rewinds the tape in the drive and opens the solenoid in the
drive handle. Go to
remove the tape.
Selects a random full slot and moves the tape to the drive. After
the tape loads, the transport moves to another slot and then
returns to the drive, unloading the tape to its home slot.
If the drive is empty, moves a tape cartridge from a random full
slot to the drive. If the drive is full, moves a tape cartridge from
the drive to the transport. It then moves the cartridge back to its
original location.
the autoloader or if all storage slots are full.
Moves a tape from a random full slot to the transport. The tape is
then moved back to its home slot.
.
Enter
.
Enter
- is displayed while the last test cycle
WAIT
OPEN DRV HANDLE
is displayed if there are no cartridges in
FAIL
.
Enter
until the number of
Next
TABLE 4-4
to open the drive and
.