Sun Microsystems SPARCstorage Library Service Manual page 115

5.1.4 Replacing the Top Cover
1. Position the top cover on top of the library with the handle toward the
back.
See Figure 5-7 on page 5-8.
2. Slide the tabs into the slots on the front panel and position the cover over
the chassis.
3. Replace the four TORX T-10 screws securing the top cover to the chassis.
5.1.5 Installing the Tape Library
Warning – The tape library weighs 90 pounds (40.86 kg). To avoid personnel
!
injury or damage to the tape library, use two or more people to remove the
tape library from the expansion cabinet.
1. Mount the tape library on the slide rails.
a. Push both slide rails completely into the cabinet.
b. With another person, position the tape library on the rails and slide it
towards the cabinet until you hear a click.
See Figure 5-6 on page 5-7.
2. Press the button in the center of the slide rails and push the tape library
completely into the cabinet.
See Figure 5-6 on page 5-7.
3. Install the four Phillips screws in the mounting brackets at the sides of
the tape library (two screws for each mounting bracket).
See Figure 5-5 on page 5-6.
4. Reconnect the SCSI cable(s) at the rear of the unit.
See Figure 5-4 on page 5-5.
Internal Access
5
5-9