Sun Microsystems SPARCstorage Library Service Manual page 122

5
5.2.3 Replacing the Right Plastic and Metal Panels
5.2.4 Replacing the Top Cover
5-16
1. Replace the metal panel to the right side of the library. Insert the tabs
into the slots at the front of the unit and secure the four TORX T-10
screws.
See Figure 5-12 on page 5-15.
2. Position the right plastic panel on the right side of the library, using the
tabs along the bottom as guides.
See Figure 5-11 on page 5-14.
3. Insert the three TORX T-20 screws.
See Figure 5-11 on page 5-14.
1. Replace the top cover, lining up the two screw holes in the cover with the
two holes on the rear edge.
See Figure 5-10 on page 5-13.
2. Insert and secure the two TORX T-20 screws.
SPARCstorage Library Service Manual—June 1995