Sun Microsystems SPARCstorage Library Service Manual page 188

D
ASC
Byte 12
40h
40h
40h
40h
40h
40h
40h
40h
40h
40h
40h
40h
40h
40h
40h
40h
D-4
Table D-2 Hardware Error Sense Key (4h) ASC and ASCQ Values (Continued)
ASCQ Display
Byte 13 Panel
Number
89h 77
90h 20
91h 21
92h 22
A0h 30
A2h 32
A3h 36
A4h 37
A5h 73
B0h 40
B1h 41
B2h 42
B3h 46
B4h 47
B5h 70
E4h 99
SPARCstorage Library Service Manual—June 1995
Description
The tape library was not in the correct control mode when
the command was executed.
To invoke commands from the Maintenance Menu, the
tape library must be in LCD Interface mode.
To run the SunDiag system exerciser, the tape library must
be in one of the Sequential modes (Sequential CTS1,
Sequential CTS2, or Dual Sequential).
Under normal operation, the tape library must be set to
SCSI Interface mode.
The gripper home sensor did not clear.
A gripper error occurred.
A gripper motion took longer than the maximum time
allocated for it. When motion functions do not complete in
the allocated time, current to the servo motors is cut off.
The CHM could not move along the short axis.
The motor on the short axis failed.
The tape library could not reset the servo chip for the short
axis.
The servo busy bit on the short axis failed.
The CHM could not reach its destination on the short axis.
The CHM could not move on the long axis.
The CHM could not return to home position on the long
axis.
The motor on the long axis failed.
The tape library could not reset the servo chip for the long
axis.
The servo busy bit on the long axis failed.
The CHM could not reach its destination on the long axis.
One of the motors is stalled. The tape library must wait
for it to cool down before operations can resume.