Table of Contents
Advertisement
2.12
Running an Internal Test
1. To run an internal test, enter the following:
ADMIN * / PSWD ### ### ### / TEST *
2. When
3. Press the
4.
NUM LOOPS 1
the desired test loop is displayed, then press
Note – Press
before cancelling.
completes.
Descriptions of the internal tests available from the control panel are in TABLE 2-8.
TABLE 2-8
Test Name
EMPTY DRIVE
REWIND MEDIA
LOAD/UNLOAD
DRIVE IO
SLOT IO
2-22
Sun
StorEdge
™
™
is displayed, press
TEST *
until the desired test is displayed, and press
Next button
is displayed, where the 1 is flashing. Press
at any time to abort a test. The last test cycle will complete
Cancel
TEST CANCEL
Tests Available From the Control Panel
Description
Used by service personnel only. Do not run this test if the Autoloader
contains a tape cartridge with data. Moves a tape out of the drive
mechanism and returns it to its home storage slot if the locations
are known, otherwise a tape is placed into the first available
storage slot.
Used by service personnel only. Do not run this test if the Autoloader
contains a tape cartridge with data. Rewinds the tape in the drive
and opens the solenoid in the drive handle. Go to
HANDLE
Selects a random full slot and moves the tape to the drive. After
the tape loads, the transport moves to another slot and then
returns to the drive, unloading the tape to its home slot.
If the drive is empty, moves a tape cartridge from a random full
slot to the drive. If the drive is full, moves a tape cartridge from
the drive to the transport. It then moves the tape back to its
original location.
Autoloader or if all storage slots are full.
Moves a tape from a random full slot to the transport. The tape is
then moved back to its home slot.
L280 User's Guide • June 1998
.
Enter
Enter
-
is displayed while the last test cycle
WAIT
to open the drive and remove the tape.
is displayed if there are no tapes in the
FAIL
Enter
until the number of
Next
.
OPEN DRV
.
Advertisement
Table of Contents
Troubleshooting
