Figure 6-7 Removing The Power Supply Screws From - Sun Microsystems SPARCstorage Library Service Manual

6
6-10
6. Remove the two TORX T-20 screws that attach the power supply to the
back of the chassis.
See Figure 6-7.
Figure 6-7 Removing the Power Supply Screws from the Back of the Chassis
7. Push the power supply away from the chassis. As you push, you will
disconnect the power supply from the J1 connector on the SMC card.
See Figure 6-6.
8. Tilt the power supply away from the back panel using both hands. Lift it
out of the tape library.
SPARCstorage Library Service Manual—June 1995
Power supply