Figure 6-17 Inserting The Drive Carriers - Sun Microsystems SPARCstorage Library Service Manual

6
6-24
5. Push the drive carriers (or drive blanks) into their slots until you feel the
connectors on the back of the drive carriers seated in the SMC controller
card.
See Figure 6-17. This action repositions the drive carriers.
Screw

Figure 6-17 Inserting the Drive Carriers

6. Replace the two flathead screws on both sides of the drive carriers.
See Figure 6-17.
7. Replace the outer cover over the back of the SMC controller card.
See Figure 6-13 on page 6-19.
a. Position the outer cover over the card with the screws at the top.
Make sure the screws go inside the frame.
b. Tighten the three captive screws.
SPARCstorage Library Service Manual—June 1995
SMC controller
card connectors