Install The Smc Controller Card - Sun Microsystems SPARCstorage Library Service Manual

6.4.3 Install the SMC Controller Card

1. Perform these steps while holding the SMC controller card in your hand:
a. Insert the CHM cable into the J9 connector (inside connector) on the
SMC controller card.
See Figure 6-16 on page 6-22.
b. Insert the display panel cable into the J10 connector (outside
connector) on the SMC controller card.
See Figure 6-15 on page 6-21.
2. Position the SMC card in its slot using the two locating pins and four
screw holes on the drive carrier frame as guides. Push against it until you
feel the SMC controller card snap onto the locating pins.
3. Locate the J1 connector on the inside upper-right corner of the SMC
controller card (J20 is on the back of the SMC controller card) that
connects to the power supply. Press against it until you feel the
connection snap into place.
See Figure 6-16 on page 6-22.
4. Replace the six TORX T-20 screws securing the SMC controller card to the
chassis.
See Figure 6-14 on page 6-20.
Removing and Installing Replacement Parts
6
6-23