Not Ready-Sense Key 2H; Hardware Error-Sense Key 4H; Table D-1 Not Ready Sense Key (2H) Asc And Ascq Values - Sun Microsystems SPARCstorage Library Service Manual

D
D.1 Not Ready—Sense Key 2h
D.2 Hardware Error—Sense Key 4h
D-2
During a Not Ready condition, the tape library returns a Check Condition
status in response to each motion command until the Not Ready condition is
removed. During this time, the sense key is set to Not Ready and the ASC and
ASCQ are set to codes specifying that the tape library is not ready. All
commands except tape motion commands, perform normally.
Table D-1 lists Not Ready sense key (2h) error conditions.

Table D-1 Not Ready Sense Key (2h) ASC and ASCQ Values

ASC ASCQ
Byte 12 Byte 13
01h
83h
04h 84h
89h
8Dh
8Eh
The tape library returns a sense key of Hardware Error (4h) when a hardware-
related error occurs. After Hardware Error occurs, the tape library will not
accept motion commands. For each additional motion command, the tape
library returns the same Hardware Error. The tape library executes all other
commands normally.
Table D-2 lists Hardware Error (4h) conditions. To determine the corrective
actions for the display panel numbers, see Table 2-1 in Section 2.1, "Error
Codes."
SPARCstorage Library Service Manual—June 1995
Description
The tape library is performing an initialization after a reset
or the door was closed.
The front door is open.
The tape library is executing ROM boot code and cannot
execute the command
The tape library is in 25-pin, 9-pin, or 4-pin serial port
mode.
The tape library is in LCD Interface mode.
The tape library is in Sequential CTS1, Sequential CTS2, or
Dual Sequential modes.