Figure 9-14 Lowering The Diskette Drive Into Place; Figure 9-15 Diskette Drive Power Cable (P3) Connector - Sun Microsystems SPARCstation 4 Service Manual

FIGURE 9-14
6. Connect the two-wire diskette drive power cable (P3) to the diskette drive power
connector.
The cable is keyed to install one way only.
FIGURE 9-15
7. Connect the keyed diskette cable to the connector on the back of the diskette
drive.
Route the diskette cable over the side and the top of the drive to the connector at the
back. When installed, the cable bends at a 90-degree angle on top of the installed
drive. See
9-14 SPARCstation 4/Xterminal 1 Service Manual • January 1995
Lowering the Diskette Drive Into Place
Diskette Drive Power Cable (P3) Connector
.
FIGURE 9-16
Diskette
data cable
Diskette drive
power cable